how to install a 1'' body lift on a 92 Jeep Wrangler

It is a piece of cake to install.

1st, unbolt all the body mounts ion the driver side & loosen the passenger side mounts. (There r 2 mounts in the rear inside the frame rails)
Look under the hood & make sure there is enough room between the fan & shroud to jack up the body an inch. If not, unbolt the fan shroud but remember to bolt it back up after u r finished.
Next, get a floor jack & a piece of wood (2x4 or 4x4) & jack up the drivers side of the body (Place the wood on the jack & under the floor board) just enough to install the 1 inch spacers.
Put the new body bolts in on the driver is side with LocTite Red.
Unbolt passenger side & jack it up. Install pucks. Install bolts.

Since it is only a 1 inch lift, u r done. No bumper mounts, steering extensions or shift linkage modifications needed.